Table 3-11
DTC
C1 201 C1 204
C1 207 C1 210
Cause
Note: Foreign materials, like ① engine oil and scrap iron in
gear may cause asymmetrical sensor signal;
Air gap means the gap between gear ring and sensor;②
If faults corresponding to more than 2 DTC can be ③
confirmed, delete the DTC (that can be deleted), drive the
vehicle at a speed of over 40 km/h, confirm the fault
corresponding to this DTC again and refer to the recorded
DTC (and confirm the same fault code).
Gear ring or sensor disturbance:
If nonstandard gear ring is installed
Elimination
procedure
To Next Page
Loading...
