1-8
Issue 9 October 1998
363-206-204
Introduction
5. These cables are required for loopback during installation testing. The optical fiber cables
can be single or multimode fiber and the recommended length is 2 feet. If Universal type
OLIUs are used, see the tables of LBOs and Fiber jumpers in your release installation
tests.
6. DSX-1 and DSX-3 patch cords normally are available for use with the DSX jack fields.
7. Available from PANDUIT Corporation. Provides easy method to notch wiring duct side-
walls down to the bottom scoreline for "T" and corner junction
8. Also see the Tools, Test Sets, and Accessories in the Installation Test chapter for the soft-
ware release being used
9. An MS-DOS
®
compatible PC and EIA-232D cable are required for software download.
To Next Page
Loading...
Need help?
General
