Manitowoc MLC650 - Page 92

Reference Only
ELECTRICAL SYSTEM MLC650 SERVICE/MAINTENANCE MANUAL
3-30
Published 09-09-16, Control # 229-09
Table 3-10. CCM-10 Test Voltages
Pin I/O Network Signal Voltages
PC1-1 OPH3A23 Left Front Jack Extend Solenoid
0V
DC
Off, 24 V
DC
On
PC1-2 OPH3A28 Left Rear Jack Retract Solenoid
0V
DC
Off, 24 V
DC
On
PC1-3 ID21 Mast Arm Limit
0V
DC
Open, 24 V
DC
Closed
PC1-4 IDF09 Not Used—For Possible Future Expansion
0V
DC
PC1-5 IDF10 Not Used—For Possible Future Expansion
0V
DC
PC1-6 ID22 Not Used—For Possible Future Expansion
0V
DC
PC1-7 IDF01 VPC Actuator Left Motor Speed Sensor Not Applicable
PC1-8 IDF04 VPC Left Motor Speed Sensor Not Applicable
PC1-9 IDF06 VPC Actuator Right Motor Speed Sensor Not Applicable
PC1-10 IACV20 Not Used—For Possible Future Expansion
0V
DC
PC1-11 IACV16 Not Used—For Possible Future Expansion
0V
DC
PC1-12 IACV18 VPC Actuator Extend Pressure Transducer
4mA @ 0psi
20 mA @ 7,500 psi
PC1-13 IACV14 Not Used—For Possible Future Expansion
0V
DC
PC1-14
+U
E
Control Module Battery Power
24 V
DC
PC1-15 OPH3A25 Right Front Jack Extend Solenoid
0V
DC
Off, 24 V
DC
On
PC1-16 CAN2_L CAN Bus C—Low Not Applicable
PC1-17 CAN2_H CAN Bus C—High Not Applicable
PC1-18 CAN4_L CAN Bus J—Low Not Applicable
PC1-19 CAN4-H CAN Bus J—High Not Applicable
PC1-20 IMID1 Module Identifier Input (from ground stud on rotating bed)
0V
DC
PC1-21 IDF03 VPC Left Motor Speed Sensor Not Applicable
PC1-22 IDF05 VPC Actuator Right Motor Speed Sensor Not Applicable
PC1-23 IACV19 Not Used—For Possible Future Expansion
0V
DC
PC1-24 IACV17 Accessory Systems Pressure Transducer
4mA @ 0psi
20 mA @ 7,500 psi
PC1-25 IACV11 Swing Right Pressure Transducer
4mA @ 0psi
20 mA @ 7,500 psi
PC1-26 OS85L Not Used—For Possible Future Expansion
0V
DC
PC1-27 KL15 Control Module Ignition Power (from engine run switch)
0V
DC
Open, 24 V
DC
Closed
PC1-28 OPH3A27 Left Rear Jack Extend Solenoid
0V
DC
Off, 24 V
DC
On
PC1-29 GND Ground (from ground stud on rotating bed)
0V
DC
PC1-30 CAN1_L CAN Bus A—Low Not Applicable
PC1-31 CAN1_H CAN Bus A—High Not Applicable
PC1-32 CAN3_L CAN Bus B—Low Not Applicable
PC1-33 CAN3_H CAN Bus B—High Not Applicable