Mitsubishi GOT1000 Series - Page 1015

25.2 Preparatory Procedures for Monitoring
25.2.3 Setting communication interface (Communication settings)
25 - 7
25
BAR CODE READER CONNECTION
26
CNC CONNECTION
27
MULTI-CHANNEL FUNCTION
28
FA TRANSPARENT FUNCTION
29
MULTIPLE-GT11 CONNECTION FUNCTION
30
GATEWAY FUNCTION INDEX
25.2.3 Setting communication interface (Communication settings)
Make the GOT communication interface settings on [Communication setting] of GT Designer2.
Select the same communication driver as the one installed on the GOT for each communication interface.
For details on [Communication setting] of GT Designer2, refer to the following manual.
GT Designer2 Version Screen Design Manual
1 Communication settings
1 Set "8" to the channel No. used.
2 Set the driver to "Barcode".
3 Perform the detailed settings for the driver. ( Communication detail settings)