Mitsubishi GOT1000 Series - Page 1112

27 - 70
27.4 Ethernet Connection
27.4.5 Setting communication interface (Communication settings)
3 Ethernet setting
(1) Ethernet setting
*1 For operating CNC monitor function, set N/W No. to “239”.
Example of Ethernet setting
For examples of Ethernet setting, refer to the following.
Section 27.4.10 CNC Side Settings
Item Description Range
Host
The host is displayed.
(The host is indicated with an asterisk (*).)
N/W No.
Set the network No. of the connected Ethernet module.
<Default: blank>
Network No. of CNC
*1
PLC No.
Set the station No. of the connected Ethernet module.
<Default: blank>
Station No. of CNC
Type
*1
Set the type of the connected Ethernet module.
<Default: QJ71E71>
AJ71QE71
IP address
Set the IP address of the connected Ethernet module.
<Default: 192.168.0.1>
IP address of CNC
Port No.
*2
Set the port No. of the connected Ethernet module.
<Default: 5001>
5001
Communication UDP (fixed) UDP (fixed)