Mitsubishi GOT1000 Series - Page 227

5.3 PLC Side Setting
5.3.2 Connecting to MELSECNET/10 network module (QnA Series)
5 - 35
1
OVERVIEW
2
BUS CONNECTION
3
DIRECT CONNECTION TO CPU
4
COMPUTER LINK CONNECTION
5
MELSECNET/10 CONNECTION (PLC TO PLC NETWORK)
6
CC-Link CONNECTION (INTELLIGENT DEVICE STATION)
7
CC-Link CONNECTION (Via G4)
8
ETHERNET CONNECTION
4 [Communication settings] of GT Designer2
[Communication Settings] of GT Designer2
For the setting method of [Communication Settings] of GT Designer2, refer to the
following.
Section 5.2.3 Setting communication interface (Communication settings)
5 Setting of the MELSECNET/10 communication unit
Setting of the MELSECNET/10 communication unit
For the setting method of the MELSECNET/10 communication unit, refer to the
following.
Section 5.2.3 Setting communication interface (Communication settings)
Item Setting (Use default value.)
Retry 3 Times
Timeout Time 3 Sec
Item Setting
Network number setting switch 1: Network No.1
Group number setting switch 0: No group setting (fixed)
Station number setting switch 2: Station number 2
Mode setting switch 0: On-line (fixed)