Mitsubishi GOT1000 Series - Page 263

6.3 PLC Side Setting
6.3.2 Connecting to CC-Link module (QnA Series)
6 - 27
1
OVERVIEW
2
BUS CONNECTION
3
DIRECT CONNECTION TO CPU
4
COMPUTER LINK CONNECTION
5
MELSECNET/10 CONNECTION (PLC TO PLC NETWORK)
6
CC-Link CONNECTION (INTELLIGENT DEVICE STATION)
7
CC-Link CONNECTION (Via G4)
8
ETHERNET CONNECTION
(3) Transmission speed setting
: Necessary : As necessary : Not necessary
*1 Specify the same transmission speed as that of the GOT.
(4) Condition setting switches
: Necessary : As necessary : Not necessary
*2 Will be valid when the CC-Link module is the local station.
In the case of the master station, turn off it.
When the switch setting has been changed
Turn the PLC CPU OFF then ON again, or reset the PLC CPU.
Transmission speed setting Description Setting Setting necessity at GOT connection
Transmission speed setting
(156kbps)
*1
0
Condition setting
switches
Setting switch
Description
Setting Setting necessity at GOT connection
SW1
Station type
(Master station / Local
station)
OFF (fixed)
SW2
Not used OFF (fixed)
SW3
SW4
Input data status of the
data link error station
(clear)
OFF
SW5
Number of stations
occupied
*2
OFF (fixed)
SW6
SW7
Not used OFF (fixed)
SW8
B RATE
0 156K
1 625K
22. 5M
35M
410M
0
1
9
8
7
6
5
4
3
2
12345678
O N
1
2
3
4
5
6
7
8
M / L
CLR
1/2
S. M
HLD
3/4
SW OFF ON
1/4 2/3