Name: Mitsubishi GOT1000 Series
Brand: Mitsubishi
Rating: 4 (1 reviews)

To Next Page

To Previous Page

13.3 Preparatory Procedures for Monitoring

13.3.6 Verifying GOT recognizes connected equipment

13 - 23

CONNECTION TO

OMRON PLC

CONNECTION TO

KEYENCE PLC

CONNECTION TO

SHARP PLC

CONNECTION TO

TOSHIBA PLC

CONNECTION TO

HIATACHI PLC

CONNECTION TO

MATSUSHITA PLC

CONNECTION TO

YASKAWA PLC

CONNECTION TO

YOKOGAWA PLC

When changing communication interface setting by Utility

The communication interface setting can be changed by the Utility.

For details on the Utility, refer to the following manual.

GT User's Manual

1 After powering up the GOT, touch [Main

Menu] [Communication setting] from

the Utility.

2 The [Communication setting] appears.

3 Verify that the following communication

driver name is displayed in the box for the

communication interface to be used.

• Communication driver (either of the

following)

HITACHI HIDIC H

HITACHI HIDIC H (Protocol2)

4 When the communication driver name is

not displayed normally, carry out the

following procedure again.

Section 13.3 Preparatory

Procedures for Monitoring

Questions and Answers:

Need help?

Do you have a question about the Mitsubishi GOT1000 Series and is the answer not in the manual?

Mitsubishi GOT1000 Series Specifications

General