13 - 26
13.4 PLC Side Setting
13.4 PLC Side Setting
HITACHI PLC
For details of the HITACHI PLC, refer to the following manual.
User's Manual for the HITACHI PLC
1 Directly connecting to the CPU
*1 Indicates only the transmission speeds that can be specified on the GOT side.
*2 Specify the transmission speed to match the transmission speed of the GOT.
For the transmission speed setting method of the GOT, refer to the following.
Section 13.3.3 Setting communication interface (Communication settings)
*3 The setting range varies according to the PLC to be connected.
2 Connecting to the intelligent serial port module
(1) For transmission control procedure1
Item Setting
Transmission speed
*1*2*3
4800bps, 9600bps, 19200bps, 38400bps
Station No. 0
Data length 7bit
Stop bit 1bit
Pairty bit Even
Control procedure DTR control
Communication format RS-232
Sum check Performed
Protocol transmission control procedure 1
Item Setting
Transmission speed 19200bps
Station No. 0
Data length 7bit
Stop bit 1bit
Pairty bit Even
Control procedure None
Communication format
For RS-232 communication: RS-232 MODE switch 2
For RS-422 communication: RS-422 MODE switch 2
Sum check Performed
To Next Page
Loading...
