Mitsubishi GOT1000 Series - Page 86

2 - 34
2.2 Preparatory Procedures for Monitoring
2.2.3 Setting communication interface (Communication settings)
(2) When connecting to other than QCPU (Q mode)
Assign the GOT to an empty I/O slot on the extension base unit.
When there is no extension base unit or no empty I/O slots are left on an extension base unit, set
an additional stage, and assign the GOT to one of the I/O slots.
(Assigning the GOT to an empty slot on the main base unit is not allowed.)
(a) When there is an empty I/O slot on the extension base unit
(b) When there are no empty I/O slots on the extension base unit
A1S35B
01
· · · · Slot No.
A1S65B
Main base unit
Extension base unit
Stage No. :1
Slot No. :2
Stage No. :1
Slot No. :3
Stage No. :1
Slot No. :4
Extension
stage 1
Stage No. setting
connector
Empty Empty
Empty Empty Empty
A1S35B
A1S65B
Main base unit
Extension base unit
Stage No. :2
Slot No. :0
Stage No. :2
Slot No. :1
Stage No. :2
Slot No. :2
Empty Empty
Extension
stage 1
Stage No. setting
connector