23.3 Preparatory Procedures for Monitoring
23 - 15
17
CONNECTION TO
ALLEN-BRADLEY PLC
18
CONNECTION TO
SIEMENS PLC
19
MICROCOMPUTER
CONNECTION
20
CONNECTION TO OMRON
TEMPERATURE
CONTROLLER
21
CONNECTION TO
YAMATAKE TEMPERATURE
CONTROLLER
22
CONNECTION TO RKC
TEMPERATURE
CONTROLLER
23
CONNECTION TO
FREQROL SERIES
INVERTER
24
SERVO AMPLIFIER
CONNECTION
23.3 Preparatory Procedures for Monitoring
The following shows the procedures to be taken before monitoring and corresponding reference sections.
Confirming the inverter side setting
This section explains the GOT side setting.
When confirming the inverter side setting, refer to the following.
Section 23.4 FREQROL Series Inverter Side Settings
Install the OS onto the GOT.
Section 23.3.1
Installing OS onto GOT
Make sure that the OS is installed on the GOT.
Section 23.3.2
Checking OS installation on GOT
Set the communication interface. (Communication
settings)
Section 23.3.3
Setting communication interface
(Communication settings)
Download the project data.
Section 23.3.4
Downloading project data
Attach the communication unit and connect the cable.
Section 23.3.5
Attaching communication unit and
connecting cable
Make sure that the GOT recognizes the connected
equipment.
Section 23.3.6
Verifying GOT recognizes connected
equipment
Make sure that monitoring is performed normally.
Section 23.3.7
Checking for normal monitoring
To Next Page
Loading...
