B - 4 MC909X Integrator Guide
7. Tap OK.
The selected application appears in the settings tab.
To determine the mobile computer’s connection status:
Tap the iDockIt
Status tab.
•
Dock Status shows either Docked and identify the type of connection (Serial, Ethernet, USB) when the mobile
computer is placed in the cradle or
Not docked when the mobile computer is removed from the cradle.
•
Connection shows the name of the connection,
•
When the mobile computer is placed in the cradle, IP addresses shows all valid IP addresses assigned to the
mobile computer. If the mobile computer is not in the cradle, this field shows either the IP address of the
network adapter or, if you there is no network connection, a default IP address.
•
The Status window shows all cradle events that have occurred since the last time the mobile computer was
placed in the cradle.
Minimize iDockIt
To minimize iDockIt, tap X in the upper right corner of the window. iDockIt controls cradle events while it is
minimized.
Exit iDockIt
To close the application, tap File > Exit. iDockIt does not control cradle events when it is closed.
General Setup Options
Settings on the General tab complement the options you set for your cradle.
Figure B-2
General Settings Tab
Enable iDockIt
Check this option to enable iDockIt to control cradle events. When you place the mobile computer in a cradle,
iDockIt identifies the type of cradle and perform the activities you have configured.
To Next Page
Loading...
Need help?
General