B - 16 MC909X Integrator Guide
Reconnect Delay
This feature has not been implemented.
USB COM Port
The first time you run iDockIt, the application attempts to determine whether the mobile computer has a USB port
and if so, the COM port to which it is mapped.
If iDockIt does not find a USB port,
None display. You can then choose from all available COM ports in the list. In
most cases, you should not have to change this setting.
Auto-dismiss Error Dialogs
You can configure iDockIt to dismiss several error dialogs that might display. To auto-dismiss an error message, tap
the check box next to its title. If the message occurs during a connection attempt, iDockIt allows it on your behalf
and the event appears in the Status window.
•
Port Disconnected
Cannot start communications with the desktop computer. The connection was terminated.
What this message means: This message is displayed when you remove the mobile computer from a cradle,
breaking the connection. Since this is not really an error, the message can be dismissed automatically.
•
Communications Error
Cannot start communications with the desktop computer. The computer is either not available or busy and
currently cannot accept connections.
What this message means: This message is displayed when ActiveSync attempts to connect to a host
computer and synchronize data but cannot find the computer name. Since this message may appear in the
course of a successful connection attempt, it can be dismissed automatically.
Status Tab
If iDockIt is enabled when you cradle the mobile computer, the Status tab displays connection-related events as
they occur. Check
Display status when cradled on the General tab if you want iDockIt to display this tab
automatically whenever you cradle the mobile computer.
Figure B-9
Status Tab
To Next Page
Loading...
