Motorola MC909X - USB Host Communication Setup

2 - 48 MC909X Integrator Guide
USB Host Communication Setup
The mobile computer can be configured as a USB host device for use with USB client devices.
To configure the mobile computer as a USB host:
1. Tap Start > Settings > System > USBConfig icon.
Figure 2-59 USBConfig Settings Window
2. Tap the USB Host Mode radio button.
3. Tap OK.
To configure the mobile computer as a USB client:
1. Tap Start > Settings > System > USBConfig icon.
2. Tap the USB Client Mode radio button.
3. Tap OK.
4. Remove the mobile computer from the cradle or CAM.
5. Re-insert the mobile computer into a cradle or re-connect the CAM.
NOTE USB Host mode is only available on Windows Mobile 5.0 devices.
NOTE When the mobile computer is configured a a USB host, it cannot ActiveSync with a host computer.