Using iDockIt B - 7
Ethernet Cradle Settings
If using an Ethernet cradle, you can establish an Internet or Intranet connection to your network and/or launch a
specified application on the mobile computer.
Figure B-4
Ethernet Settings Tab
Establish Network Connection
Check this option to have iDockIt establish a network connection when you cradle the mobile computer.
You can check this option in conjunction with
Launch application. After iDockIt establishes the network connection,
it launches the specified application.
Launch Application
Check this option to have iDockIt launch the selected application when you cradle the mobile computer. iDockIt
uses the specified command line parameters. You must select an application to launch.
Select...
1. Tap Select to open the Select Auto-Launch Application dialog.
2. Select a File Type in the drop-down list.
3. Select a Folder (as needed).
4. Select a file name in the list.
5. Use the input panel to specify command line parameters.
6. Tap OK at the top of the screen.
The selected application appears in the settings tab.
Serial Cradle Baud Rate
This option allows you to specify the baud rate iDockIt should use for a serial connection to the Ethernet cradle. Set
this rate to match the baud rate configured for the cradle. For maximum performance, always use the maximum
baud rate of 115200.
NOTE You cannot use ActiveSync 4.0 or later to synchronize data between a host computer and a Windows CE
based device through an Ethernet cradle.
To Next Page
Loading...
Need help?
General