• If the media thickness detection menu is set to "Off", media thickness is not
detected; follow the procedure below to set the media thickness (value).
1. When "Warning! *.* mm ->" (" * " stands for a numerical character) is displayed on
the operation panel, check if the value matches the thickness of the loaded media.
If the value is wrong, enter the correct setting value.
• If you can't figure out the correct value, press the [Cancel] key. The printer starts
detecting the media thickness.
• If a wrong value is set, the head and media collide and may damage the head.
2. Press the [Enter] key.
3. When "Misuse Damages Unit>" is displayed on the operation panel, press [>] key
for more than two seconds.
4. When "<E>Skip <CAN>Detect" is displayed on the operation panel, press the
[Enter] key.
• The printer starts performing media initial operation.
• If you press the [Cancel] key, thickness of the media will be detected.
5.2.2.7.2 Media width/top edge detection (media initial 2)
5.2.2.8 Media Width/Width check menu
Media width/Width check menu varies depending on the settings of Media width/top edge detection
menu.
• When the media width/top edge detection menu is set to Off, you can enter the media width between
5 mm from the loading mark of Paper guide F and the left edge of the media
5.2.2.8.1 Media Width menu
Setup item Setting Description
Media Off The media width and top edge are not detected during media
initialization.
Set the media width in the media width menu.
5.2.2.8 Media Width/Width check menu
Top&Width Detect the media width and top edge during media
initialization.
<Width> Media width is detected during media initialization.
Top edge of the media is not detected.
— • [Enter] key: saves the setting and shifts to the previous
menu.
• [Cancel] key: cancels the setting and shifts to the previous
menu.
•
5.2.2.7 Media Initial menu
To Next Page
Loading...
Need help?
General