VJ-1617H OPERATION MANUAL Maintenance
6-35
• Use genuine ink bags for replacement.
This printer is designed to use genuine ink bags.
If you use an ink bag that is not a product of the original manufacturer,
• Printing might become blurred, or the end of the ink in the bag might not be detected correctly.
• Any problems caused by using an ink bag other than those recommended above will not be
covered by the warranty, and repair expenses will be paid by the customer.
(3) Replacing steps
Follow the procedure below to replace the ink bags.
• When handling ink bags, pay attention so that ink does not get into your eyes or
stick to your skin.
If ink gets into your eyes or sticks to your skin, immediately wash it off with water.
Failing to do so might cause irritation or light inflammation of eyes.
In case of any abnormality, consult a physician immediately.
• Do not disassemble the ink bags.
If disassembled, there is a possibility that ink might come into contact with eyes or
skin.
• Do not give ink bags strong shakes.
Doing so may cause ink leakage.
• Do not disassemble the ink bags.
A disassembled ink bags cannot be used.
• When an ink bag is moved from a cold place to warm place, keep the ink bag for three hours or
more in the new printing environment before printing.
• Do not refill an ink bag with ink.
It may result in abnormal printing.
1. Confirm that the printer is turned ON.
• Do not replace ink bags when the printer is turned OFF.
The remaining ink may not be detected correctly, causing abnormal printing.
2. Remove all High-capacity pack adapters you want to replace.
To Next Page
Loading...
Need help?
General