•If an error has occurred at Blower heater in the Printer Link mode, "Heater Error" is displayed on Operation panel as well.
No. Name Color Status Description
5 RUN/STOP switch Green Lamp
OFF
Blast is stopped.
Blinking
(slow)
Heater is warming up.
(LED blinks once per second)
Lamp
ON
Heater is warmed up.
Blinking
(medium
speed)
Heater is cooling down at the time of power-off.
(LED blinks twice per second)
Blinking
(fast)
An error has occurred at Blower heater.
Turn the power OFF.
(LED blinks four times per second)
4.5.2 Turning Blower heater OFF
6 Link switch Green Lamp
OFF
Blower heater is set to “Manual” mode.
Lamp
ON
Blower heater is set to “Printer Link” mode.
Blinking
(medium
speed)
The communication error between Blower heater and Printer has occured.
Turn the printer OFF if it’s ON.
Operate the printer in Manual mode if it’s status is ON.
(LED lamp blinks twice per second.)
Blinking
(fast)
A Blower hearter error has occured
Turn the printer OFF.
(LED lamp blinks about four times per second.)
4.5.2 Turning Blower heater OFF
To Next Page
Loading...
Need help?
General