• Do not pull out or insert the power plug with a wet hand.
This could lead to an electric shock.
• Make sure to use only the specified power supply (AC 100 V to 120 V or AC 220 V to
240 V).
If a power supply other than the specified voltage is used, it could cause an electric
shock and fire.
• Take power for the printer directly from the power socket (AC 100 V - 120 V or AC
220 V - 240 V).
Do not use multiple plugs on the same socket.
This could generate heat and might cause fire.
• Be sure to use a dedicated power socket with earth wire for the power supply, and
connect it to the earth wire.
If the earth wire is not connected, an electric shock or fire may occur.
• Do not connect an earth wire to the following places.
• Gas pipe
There is a possibility of ignition and explosion.
• Earth wire of telephone cables and lightning rods
Heavy current might flow whenever lightning strikes.
• Water pipe and faucet
The earth might not work if a plastic pipe is connected in the middle of the metal
pipe.
To Next Page
Loading...
Need help?
General