• Pay attention to the following points when handling the power supply plug.
Any mishandling of the power cable could cause a fire.
• Make sure that no foreign substances such as dust etc. are stuck to the power
plug.
• Make sure that the power plug is firmly inserted to the edge of the power socket.
• When you do not use the printer for a long period, make sure to pull out the power
plug from the power socket for safety.
• If you are leaving the printer unplugged for a long time, follow the procedure in
"
6.3.1 Operation procedure for long storage" to turn the power OFF, and then unplug the
power plug.
• Make sure to connect an earth wire to the earth connection that meets the following
standards.
• Earth terminal of power socket
• Earth wire with copper plate which is buried at 650 mm or more, deep in the
ground.
• Earth wire with copper plate which is buried at 650 mm or more, deep in the
ground.
• Contact the retail outlet of purchase if the earth connection cannot be established, or if the earth
connection is not given.
• When the power supply of the printer is ON, do not pull out the power cable from the power socket.
Whenever the plug is pulled out from the power socket, allow one minute or more before inserting
the plug in the power socket again.
• When connecting 3 power cables, the following capacity is required.
If the capacity is beyond the outlet you are using, connect it to another outlet.
• 100V-120V: Total of 18A (2A on the main side, 8A on Heater 1 side, and 8A on Heater 2 side)
• 200V-240V: Total of 10A (1A on the main side, a total of 9A on Heater 1 and Heater 2)
To Next Page
Loading...
Need help?
General