NETGEAR ProSAFE WC7500 User Manual

System Planning and Deployment Scenarios
51
ProSAFE Wireless Controller
4. Deploy the access points and connect them to PoE switches.
5. When the access points are operating, open the Discovery
Wizard to do the following:
Access Point > Discovery Wizard
1. Specify the state of the access points, which is the factory
default state in a Layer 2 network.
2. Run the Discovery Wizard.
3. Select and add the access points that you want to be managed
by the wireless controller to the managed list.
Note: By default, all access points are added to the basic group.
6. Assign the access points to the access point profile groups (also
referred to as WLAN groups) Building 1 and Building 2.
Configuration > WLAN Network
Step Configuration Web Management Interface Path

NETGEAR ProSAFE WC7500 Specifications

General

Brand	NETGEAR
Model	ProSAFE WC7500
Category	Controller
Language	English