NF BP4610 - Page 148

5.3 Explanation of Each Program Message
BP4610
5-14
 Example of sequence programming using program messages
An example of programming that sets the sequence transitions shown in Figure 4-20 using USB
program messages is described below.
STPN 1
SEXP 2.5, 2, 0, 0, 0, 0, 2, 0, 0, 0
STRP 0, 0.1, 0, 0, 0, 0, 0, 0, 0
STPN 2
SEXP 2.5, 1, 0, 0, 0, 0, 2, 0, 0, 0
STRP 0, 0.2, 0, 0, 0, 0, 0, 0, 0
STPN 3
SEXP 7.5, 0, 0, 0, 0, 0, 2, 0, 0, 0
STRP 0, 0.1, 0, 0, 0, 0, 0, 0, 0
STPN 4
SEXP 5, 2, 0, 0, 0, 0, 2, 0, 0, 0
STRP 0, 0.2, 0, 0, 0, 2, 1, 0, 0
STPN 5
SEXP 10, 2, 0, 0, 0, 0, 2, 0, 0, 0
STRP 0, 0.2, 0, 0, 0 0, 0, 6, 0
STPN 6
SEXP 0, 2, 0, 0, 0, 0, 2, 0, 0, 0
STRP 0, 0.3, 0, 0, 1, 0, 0, 0, 0