Oce 9600 - Page 144

144 Océ 9600 Copier/Printer User Manual
Input mode
Description
The ‘Input mode’ allows you to define the type of input:
Single sheet
: No sorting will be used. Each page is put in a
separate job.
Multiple sheets
: Sort by page job where, until the set is
closed, all originals will belong to the same job (e.g. 11111
- 22222 - 33333).
Set
: Sort by set job (e.g. 123 - 123 - 123 - 123 - 123)
Min/max values
N/A
Menu path
Jobs - Copy & File - Defaults - Original - Feeding -Input
mode - <value> - Apply
Legend location
Description
You can use the ‘Legend location’ option to determine if us-
ers will feed in the original with the legend on the leading
edge or on the trailing edge.
This information is used to fold the copy in such a way that
the legend is always on top of the folded package.
Min/max values
N/A
Menu path
Jobs - Copy & File - Defaults - Original - Feeding - Legend
location - <value> - Apply
Remove leading strip
Description
Use the ‘remove leading or trailing strip’ settings to set the
removal of a blank strip at the top or bottom of the image as
default. The print length will decrease accordingly.
‘Remove leading strip’ will remove a blank strip at the top of
the image.
‘Remove trailing strip’ will remove a blank strip at the bot-
tom of the image.
You can remove up to 400 mm or 16 inches in increments of
1 mm.
By default, no leading or trailing strip is defined.
Remove leading or trailing strips will always work, unless
you try to remove the entire plot.
Min/max values
N/A
Menu path
Jobs - Copy & File - Defaults - Original - Sheet - Remove
leading / trailing strip - <value> - Apply