Oce 9600 - Page 95

Scan to file 95
4
Click Ok to accept the destination settings.
The destination properties are now locked.
Note:
This option is only available if you are logged on as a Key operator (see
chapter, ‘User modes’ on page 121).
▼
▼▼
▼
Unlock a destination
1
Select a destination.
2
Open the ‘File’ menu and select ‘Properties’.
3
Uncheck the ‘Locked’ check box.
4
Click Ok to accept the destination settings.
The destination properties are now unlocked.
Note:
This option is only available if you are logged on as a Key operator (see
chapter, ‘User modes’ on page 121).
▼
▼▼
▼
Delete a destination
1
Select a destination.
2
Open the ‘File’ menu and select ‘Delete’ or click the ‘Delete’ button on the
toolbar (see figure 50).
[50] ‘Delete’ button on the toolbar
The selected destination is deleted.
Note:
This option is only available if you are logged on as a Key operator or
as a Repro operator.
Note:
You are not able to delete the last destination.
▼
▼▼
▼
Define file name
1
Select a destination.
2
Open the ‘File’ menu and select ‘Properties’.
The ‘Destination properties’ screen appears as in figure 49 on page 94.
3
Enter a name in the ‘Base name’ textbox.
Note:
The ‘Base name’ may contain ‘###’ for automatic file naming. The
‘###’ will be replaced by an ascending number. You may place an equal
amount of dots in the ‘Base name’.
4
Check or uncheck the ‘Add appropriate file extension’ check box to add or
respectively leave out an appropriate file extension. The file extension can be
set in the Settings Editor (see ‘File extension TIFF’ on page 155 or ‘File
extension CALS’ on page 155).
5
Click Ok to accept the settings.