– Cabling Diagrams : Added additional Exalogic wiring configurations.
– Replacement Units: Added note about the spares kit for Exalogic.
– Cabling Tables: Corrected errors in the networking tables.
• E18478-12: February 2013
– Parts for Sun Server X3-2 Compute Nodes: Added the replacement part
numbers of the new BBU.
– Create an IPoIB Partition and Adding Ports: Corrected the smpartition
command syntax in step 3.
•
E18478-11: December 2012
– Hardware Components of Exalogic: Added generic link that points to both
X2-2 and X3-2 data sheets.
– Environmental Requirements: Added generic link that points to both X2-2
and X3-2 data sheets.
•
E18478-10: October 2012
– Environmental Requirements: Added environmental requirements for X3-2.
– Create an IPoIB Partition and Adding Ports: Added steps for configuring the
storage appliance when creating IB partitions.
– Chapter 16, "Monitoring the Exalogic Machine Using Oracle Enterprise
Manager Ops Center": Added information, up front, to clarify the scope of the
content in this chapter.
– Replacement Units: Added replacement parts list for the new hardware
components in X3-2.
– Rebranded the document cater to both X3-2 and X2-2.
• E18478-09: September 2012
– Configure Ethernet Over InfiniBand:
Updated the procedure to set up EoIB on Oracle Linux and Oracle Solaris, to
correct certain errors and inconsistencies.
Added information about the recommended naming convention for VNICs
on Oracle Linux.
– Subnet Manager Operation in Different Rack Configurations:
Updated Table 13-1 to make the information clearer.
Added information for running the SM in rack configurations with varying
switch-firmware versions.
– Create a Partition for EoIB and Associating the pkey with a VNIC and VLAN:
Added information about the recommended naming convention for VNICs
on Oracle Linux.
– Configuration Tasks: Updated with information about contacting Oracle
Advanced Customer Support.
xix