Switch#write memory
Building configuration...
Compressed configuration from 3784 bytes to 1465 bytes [OK ]
Switch# show clock
21:00:06.643 EST Wed Dec 9 2009
11. Configure up to two NTP servers. The following is an example:
Switch# configure terminal
Enter configuration commands,one per line.End with CNTL/Z.
Switch(config)# ntp server 10.7.7.32 prefer
Switch(config)# ntp server 129.148.9.19
Switch(config)# end
*Sep 15 14:51:08.665:%SYS-5-CONFIG_I:Configured from console by
console
Switch# write memory
Building configuration...
Compressed configuration from 2654 bytes to 1163 bytes [OK ]
Switch# show ntp status
<output will vary per network>
Switch# show clock
20:59:06.643 EST Wed Dec 9 2009
The preceding should show the NTP server synchronized to local time if the Cisco
switch is connected to the network and has access to NTP.
12. Verify the configuration using the following command:
Switch# show running-config
The following is an example of the output:
Building configuration...
Current configuration :2654 bytes
!
version 12.2
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
service compress-config
!
hostname Switch
!
boot-start-marker
boot-end-marker
!
enable secret 5 $1$mS8h$EaJrIECUxavfGH6vLZg1T.
enable password Your_Password
!
no aaa new-model
ip subnet-zero
ip domain-name sodm.com
ip name-server 10.7.7.3
ip name-server 172.16.5.5
ip name-server 10.8.160.1
!
ip vrf mgmtVrf
!
vtp mode transparent
!
power redundancy-mode redundant
Initial Network Configuration of Exalogic Machine
Add the Exalogic Machine to Your Network 5-9
To Next Page
Loading...
Need help?
General
