In the preceding example, the first login output shows the password has not been
set, and telnet access is disabled. If the login command returns nothing, then the
password is set and telnet access is available.
9. Configure up to three DNS servers. The following is an example:
Switch# configure terminal
Enter configuration commands,one per line.End with CNTL/Z.
Switch(config)# ip domain-name exdm.com
Switch(config)# ip name-server 10.7.7.3
Switch(config)# ip name-server 129.148.5.5
Switch(config)# ip name-server 10.8.160.1
Switch(config)# end
*Sep 15 14:26:37.045:%SYS-5-CONFIG_I:Configured from console by console
Switch#write memory
Building configuration...
Compressed configuration from 2603 bytes to 1158 bytes [OK ]
10.
Set the clock and time zone as follows. The switch keeps internal time in
Coordinated Universal Time (UTC) format.
• To use UTC use the following command:
no clock timezone global configuration
• To use a time zone, use the following command:
clock timezone zone hours-offset [minutes-offset]
In the preceding command, zone is the time zone to display when standard
time in effect, hours-offset is the hours offset from UTC, and minutes-offset is the
minutes offset from UTC.
• To set summer time hours, use the following command:
clock summer-time zone recurring [week day month hh:mm week day month \
hh:mm [offset]]
In the preceding command, zone is the time zone to be displayed when
summer time is in effect, week is the week of the month (1 to 5 or last), day is the
day of the week, month is the month, hh:mm is the time in 24-hour format, and
offset is the number of minutes to add during summer time. The default offset
is 60 minutes.
• To manually set the clock to any time, use the following command:
clock set hh:mm:ss month day year
In the preceding command, hh:mm:ss is the time in 24-hour format, day is the
day of the month, month is the month, and year is the year. The time specified is
relative to the configured time zone.
To set the local time and time zone, ordering is important. The following is an
example of setting local time to US Eastern time:
Switch# configure terminal
Enter configuration commands,one per line.End with CNTL/Z.
Switch(config)# clock timezone EST -5
Switch(config)# clock summer-time EDT recurring
Switch(config)# end
Switch# clock set 21:00:00 December 09 2009
Initial Network Configuration of Exalogic Machine
5-8 Oracle Exalogic Elastic Cloud Machine Owner's Guide
To Next Page
Loading...
Need help?
General
