17.2 I/O Number Allocation
17-9
Contact
allocation
Target axis Name Description
WX7
X70
|
X7F
− − −
WX8
X80 1st axis
Synchronous
setting done
Make synchronous settings in the unit with the synchronous setting
request contact (Y80 to Y83) turned ON after making synchronous
setting changes with the program. The contact turns ON upon
completion of the setting changes.
X81 2nd axis
X82 3rd axis
X83 4th axis
X84
|
X87
− − −
X88 1st axis
Synchronous
cancel alarm
Turns ON when the synchronous operation of the positioning unit is
canceled with the synchronous setting cancel request contact (Y88 to
Y8B) turned ON.
The synchronous operation of axes cannot be executed if this contact is
ON for the axes.
X89 2nd axis
X8A 3rd axis
X8B 4th axis
X8C
|
X8F
− − −
WX9
X90 1st axis
Slave axis
gear ratio
change notice
Makes gear ratio changes with the salve axis gear ratio change request
contact (Y90 to Y93)
The contact for the corresponding axis will turn ON after the gear ratio is
changed.
X91 2nd axis
X92 3rd axis
X93 4th axis
X94
|
X97
− − −
X98 1st axis
Slave axis
clutch operation
notice
The clutch will start operating when the slave axis clutch ON re-request
contact (Y98 to Y9B) or clutch OFF request contacts (Y100 to 103) turn
ON.
The contact for the corresponding axis will turn ON after completion of
the operation of the clutch.
X99 2nd axis
X9A 3rd axis
X9B 4th axis
X9C
|
X9F
− − −
WX10
X100
|
X10F
− − −
WX11
X110
|
X11F
− − −
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
To Next Page
Loading...
