7.19
FINAL DRIVE
7
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
Gearcase Removal
1. Stop engine and place gear selector in Park.
2. Refer to “FRONT DRIVE SHAFT - Drive Shaft
Re
moval” and remove both front drive shafts from the
front gearcase.
3. Remove the propshaft (see “PROPSHAFT
SERVICE”).
4. Disconnect the wire harness above the front gearcase
a
nd remove the harness from the retaining dart.
5. Remove the vent line from the front gearcase.
6. Remove the (4) bolts securing the front gearcase to
frame.
7. Remove the gearcase from the front LH wheel well
a
rea and slide it between the upper and lower A-arm.
Gearcase Disassembly / Inspection
1. Drain and properly dispose of gearcase fluid.
Remove any metal particles from the drain plug
magnet.
2. Remove the (7) cover screws
and remove the cover
plate assembly.
Remove
Remove
Vent Line
Disconnect
Harness
Gearcase image is
for reference only.
4 Bolts
To Next Page
Loading...
