Polycom HDX 7000 Series User Manual

Polycom, Inc. 10–1
10
Control Devices
Configuring Remote Control Behavior
You can customize the behavior of the remote control to support a user’s
environment.
To configure remote control behavior:
1 Do one of the following:
— In the local interface, go to System > Admin Settings > General
Settings > System Settings > Remote Control/Keypad (select if
necessary).
— In the web interface, go to Admin Settings > General Settings >
System Settings.
Points to Note about remote control behavior:
• If the Polycom HDX system is paired and connected with a Polycom Touch
Control, the remote control is disabled.
• Polycom HDX 8000 series, Polycom HDX 7000 series, and Polycom HDX 6000
series systems must be connected to a camera with an IR receiver to receive
signals from the remote control. Be sure to point the remote control at the
camera to control those Polycom HDX systems. Refer to the “Interoperability”
section of the current HDX system release notes for a list of supported cameras
with IR receivers.
• The Polycom HDX remote control IR transmits a modulated frequency of
38 kHz.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Polycom HDX 7000 Series Specifications

General

Content Sharing	H.239, People+Content
Microphone	Polycom HDX Microphone Array
Network Protocols	H.323, SIP
Data Standards	H.239
Video Outputs	2 x DVI-I
Operating Temperature	0°C to 40°C (32°F to 104°F)
Video Standards	H.264, H.263, H.261
Video Resolution	Up to 1920 x 1080
Audio Standards	G.711, G.722.1, G.729A
Camera	Polycom EagleEye Camera
Connectivity	Ethernet, ISDN
Video Inputs	DVI-I
Audio Inputs	RCA
Audio Outputs	RCA
Network Interfaces	10/100/1000 Ethernet
Power Supply	100-240V AC, 50/60Hz