Administrator’s Guide for Polycom HDX Systems
6–4 Polycom, Inc.
To enable or disable multipoint trial mode:
1 Do one of the following:
— In the local interface, go to System > Admin Settings > General
Settings > Options.
— In the web interface, go to Admin Settings >General Settings >
Options.
2 Select Enable Multipoint Trial to allow five-minute multipoint calling
without the multipoint option key.
Configuring the Conference on Demand Feature
If your organization uses a Polycom PathNavigator, ReadiManager SE200, or
CMA system, you may be able to use the Conference on Demand feature to
place multipoint calls with up to 10 sites, including the site that places the call.
In order to place calls using Conference on Demand, you need to:
• Register your Polycom HDX system with PathNavigator, ReadiManager
SE200, or CMA system.
• Configure your Polycom HDX system to use Conference on Demand for
multipoint calls (refer to Configuring the System to Use a Gatekeeper on
page 2-9).
• Create a group in the directory that can be used to place the multipoint
call.
Including Multiple Sites in a Cascaded Call
You can include multiple sites in a cascaded call if the sites you call have
internal multipoint capability.
Points to note about Conference on Demand:
• Once the call begins, users cannot add another site to the call, even if the site
was in the call originally and is attempting to rejoin. Because of this, you cannot
place cascaded multipoint calls through Conference on Demand.
• The Polycom MGC or RMX system must have enough ports available to
complete the call. The system displays a message if the bridge does not have
enough ports (resources) available to connect all the sites.
• RealPresence Resource Manager does not support Conference on Demand.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
