Administrator’s Guide for Polycom HDX Systems
11–8 Polycom, Inc.
Reset or Restart System
Send a Message
This setting appears in the web interface only. Use this setting to send a
message to the embedded interface of a Polycom HDX system you are
managing.
System Log
This setting appears in the web interface only. For information about using
system logs, refer to System Logs on page 11-13.
Sessions
This setting appears in the local interface only. When you select the setting,
information about the sessions that are currently running on the HDX system
is displayed.
Diagnostic Tool Description
Restart (web only)
Reset System
(system only)
Restart in the web interface cycles power to the system.
Note: If a password is set, you must enter it to reset the
system.
When you choose Reset System using the remote
control, the system’s user interface allows you to do the
following:
• Keep your system settings (such as system name and
network configuration) or restore factory settings.
• Keep or delete the directory stored on the system.
System reset does not affect the global directory.
You may want to download the CDR and CDR archive
before you reset the system. Refer to Call Detail Report
(CDR) on page 11-9.
Diagnostic Screen Description
Type Displays the type of connection, for example, Web.
User ID Displays the ID of each user who is logged in.
Remote Address Displays the IP addresses of people logged in to the HDX
system from their computers.
Duration Displays the duration of the session in hours, minutes, and
seconds for each user currently logged in.
Idle Displays how long the session has been idle, in seconds.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
