Introducing the Polycom HDX Systems
Polycom, Inc. 1–17
The setup wizard allows you to set an Admin ID and password, which allows
you to limit access to the Admin Settings. The default Admin ID is
admin
and
the default admin room password is the 14-digit system serial number from
the System Information screen or the back of the system. Admin and User IDs
are not case sensitive.
You can run the setup wizard or view the configuration screens in either of
these two ways.
• In the room with the system — Use the remote control to navigate the
screens and enter information. You can use the number pad on the remote
control to enter text. Point the remote control at the camera to control
Polycom HDX 8000 series, Polycom HDX 7000 series, and Polycom HDX
6000 series systems.
• From a remote location — If you know the IP address of the system, you
can access and configure the HDX system by using the HDX web interface.
For more information about using the web interface, refer to Accessing the
Polycom HDX Web Interface on page 9-1.
The setup wizard is available during initial setup, after a software update or
system reset with system settings deleted, or after using the restore button.
Admin Settings
After you run the setup wizard, you can view or change the system’s
configuration by going to the Admin Settings in the system’s local interface or
web interface.
If you enable a security profile in the setup wizard, certain configuration
settings are set and controlled automatically.
If you enable a provisioning service, any settings provisioned by the Polycom
Converged Management Application
®
(CMA
®
) or Polycom RealPresence
®
Resource Manager system may be displayed as read-only settings in the
Polycom HDX system interface. For more information about automatic
provisioning, refer to the Polycom CMA or RealPresence Resource Manager
system documentation on the Polycom web site.
Make sure you can recall the room password if you set one. If you forget the
password, you must use the restore button to run the setup wizard again in order to
access the Admin Settings and reset the password. For more information, refer to
Using the Restore Button on the Polycom HDX System on page 12-2.
When a Polycom HDX system is paired with a Polycom Touch Control, the following
statements are true:
• You can change the system’s configuration using the web interface only.
• When prompted to enter the Admin Room ID and password and no Admin
Room ID is configured, you can submit a blank password.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
