Polycom realpresence group series

System Commands
Polycom, Inc. 408
wanipaddress
Gets or sets the WAN IP address.
Syntax
wanipaddress get
wanipaddress set [“xxx.xxx.xxx.xxx”]
Feedback Examples
● wanipaddress set 192.168.1.101
returns
wanipaddress 192.168.1.101
● wanipaddress get
returns
wanipaddress 192.168.1.101
Limitations
None
Comments
The NAT Configuration option on the Firewall screen must be set to Auto, Manual, or UPnP for this option
to be available.
Parameter Description
User
Accessible Additional Restrictions
get Returns the WAN IP address. ✓
set Sets the WAN IP address when followed
by the “xxx.xxx.xxx.xxx” parameter.
To erase the current setting, omit the
“xxx.xxx.xxx.xxx” parameter.
“xxx.xxx.xxx.xxx” WAN IP address.