Polycom realpresence group series

System Commands
Polycom, Inc. 260
ipaddress
Gets or sets the LAN IP address (IPv4) of the system.
Syntax
ipaddress get
ipaddress set “xxx.xxx.xxx.xxx”
Feedback Examples
● ipaddress set 192.168.1.101
returns
ipaddress 192.168.1.101
● ipaddress get
returns
ipaddress 192.168.1.101
Limitations
None
Comments
Use this command when you need to allocate a static IP address to your system.
After making a change, you must restart the system for the setting to take effect.
Parameter Description
User
Accessible Additional Restrictions
get Returns the current setting. ✓
set Sets the LAN IP address to the
“xxx.xxx.xxx.xxx” parameter. This
setting can only be changed when DHCP
is off.
“xxx.xxx.xxx.xxx” IP address of the system.