System Commands
Polycom, Inc. 259
sourceman.camera[1].saturation,"6"
sourceman.camera[1].sharpness,"3"
sourceman.camera[1].videoquality,"Sharpness"
sourceman.camera[1].whitebalancemode,"atw"
video.monitor[1].Resolution,"1920x1080p 60Hz"
video.monitor[2].Resolution,"1920x1080p 60Hz"
importcomplete
importprofile succeeded
Limitations
None
Comments
When importing profile data, the imported data must be in the same format as was obtained from the system
using the exportprofile command or the export profile utility in the web interface. When importing profile
data back into the system, use the data in its entirety (not edited in any form). The system may use the
checksum utility to verify of integrity of the data when it is imported back into the system.
importprofile done indicates that all the profile data has been imported.
When the system uses the Maximum security profile, this command is available only to Administrators.
A restart of the system is required after successfully importing system and user profile information and
occurs automatically after the import is complete.
You must include the importcomplete command as the last entry. Issuing the importcomplete
command on its own line indicates that the profile import is complete. If no data is received for 60 seconds
during import, the import ends, and an importprofile timed out
error response displays. All previous
data entered is ignored.
The system might not allow certain parameters, such as passwords or software build information, to be
updated during the import process. Logs messages indicate if a parameter is ignored during the import
process.
Exporting a profile on one system model and importing the profile on another model is not supported.
Attempts to export and import profile information between different systems might also fail. The message
importprofile failed
indicates that the system was not able to import the information.
See Also
See the exportprofile command.
To Next Page
Loading...
Need help?
General
