System Commands
Polycom, Inc. 306
preset
Sets the presets or goes (moves) to the presets for the near or far camera source. Also registers or
unregisters the API session to give notification when the user sets or goes to presets.
Syntax
preset <register|unregister>
preset register get
preset far <go|set> <{0..15}>
preset near <go|set> <{0..99}>
Feedback Examples
● preset register
returns
preset registered
● preset near go 1
returns
preset near go 1
and moves the near-site camera to the preset 1 position
● preset near set 2
returns
preset near set 2
and saves the current location/position of the near-site camera as preset 2
Parameter Description
User
Accessible Additional Restrictions
register Registers the system to give notification when
the user or far site sets or goes to a preset.
Returns the current preset registration state
when followed by the get parameter.
unregister Disables register mode.
far Specifies the far camera. Requires a set or
go parameter and a preset identifier.
go Moves the camera to a camera preset.
Requires a “preset” parameter.
set Sets a camera preset. Requires a “preset”
parameter.
{0..15},
{0..99}
Camera preset identifier. Must be an integer in
the range {0..15} for a far-site camera or
{0..99} for a near-site camera.
near Specifies the near camera. Requires a set or
go parameter and a preset identifier.
To Next Page
Loading...
Need help?
General
