SERVICE PROGRAM MODE
B121 Series/B259 Series 5-44 SM
NCS 5801 11
Initializes the network-control-service settings: the system defaults and interface
settings (including IP addresses), Smart Net Monitor for Administrator, Web Status
Monitor settings, and the TELNET settings.
R-Fax 5801 12
Initializes the job log in ID, Smart Net Monitor for Administrator, job history, and
local storage file numbers.
5801 14 Clear DCS Settings
5801 15 Clear UCS Settings
5802
Machine Free Run
5802 1 Starts a free run of both the scanner and the printer. Press "ON" to start; press
"OFF" to stop.
Input Check
5803
5.1.8
Output Check
5804
5.1.9
5807*
Area Selection
5807 1 Selects the display language group.
1 Japan 2 North America 3 Europe 4 Taiwan
5 Asia 6 China 7 Korea
SP5-807-001 is not cleared by SP5-801-001 and SP5-998-001 ( 5.1.7).
5811*
Serial Num Input
5811 1 5.1.10
5812*
Service TEL
Service TEL (Telephone) 5812 1
Use this to input the telephone number of the service representative. (The number
is displayed when a service call condition occurs.) To input a dash, press . To
delete the current telephone number, press .
Service TEL (Facsimile) 5812 2
Use this to input the fax number printed on user counter reports. To input a dash,
press . To delete the current fax number, press .
Rev. 7/2004
To Next Page
Loading...
