BIT SWITCHES
SM 25 B620
Fax Option
B620
System Switch 0A SP No. 1-101-011
No FUNCTION COMMENTS
0-3 Not used Do not change the settings.
4
Dialing on the ten-key pad
when the external telephone is
off-hook
0: Disabled 1: Enabled
0: Prevents dialing from the ten-key pad while the
external telephone is off-hook. Use this setting when
the external telephone is not by the machine, or if a
wireless telephone is connected as an external
telephone.
1: The user can dial on the machine’s ten-key pad
when the handset is off-hook.
5
On hook dial
0: Disabled 1: Enabled
0: On hook dial is disabled.
6-7 Not used Do not change the settings.
System Switch 0B - Not used (Do not change the factory settings.)
System Switch 0C - Not used (Do not change the factory settings.)
System Switch 0D - Not used (Do not change the factory settings.)
System Switch 0E SP No. 1-101-015
No FUNCTION COMMENTS
0-2 Not used Do not change the settings.
3
Action when the external
handset goes off-hook
0: Manual TX and RX operation
1: Memory TX and RX
operation (the display remains
the same)
0: Manual TX and RX are possible while the
external handset is off-hook. However, memory TX
is not possible.
1: The display stays in standby mode even when
the external handset is used, so that other people
can use the machine for memory TX operation.
Note that manual TX and RX are not possible with
this setting.
4-7 Not used Do not change the settings.
System Switch 0F SP No. 1-101-016
No FUNCTION COMMENTS
0
to
7
Country/area code for functional
settings (Hex)
00: France 11: USA
01: Germany 12: Asia
02: UK 13: Japan
03: Italy 14: Hong Kong
04: Austria 15: South Africa
05: Belgium 16: Australia
06: Denmark 17: New Zealand
07: Finland 18: Singapore
08: Ireland 19: Malaysia
09: Norway 1A: China
0A: Sweden 1B: Taiwan
0B: Switz. 1C: Korea
0C: Portugal 20: Turkey
0D: Holland 21: Greece
0E: Spain 22: Hungary
0F: Israel 23: Czech
10: Canada 24: Poland
This country/area code determines the factory
settings of bit switches and RAM addresses.
However, it has no effect on the NCU parameter
settings and communication parameter RAM
addresses.
NOTE: Please be sure to keep the following in mind
when installing the optional FAX:
After changing the Bit SW setting for the
country code (System Switch 0F), do not
use the scroll key to go to the next bit
setting. Instead, turn the main power
ON/OFF to activate the country code
setting, and then go on to the next settings.
If the scroll key is used just after the country
code is set, other bits may be changed.
Cross reference
NCU country code: SP2-103 parameter C.C.
Rev.09/2005
⇒
To Next Page
Loading...
