• Do not use an SD card if it was used with a computer before this time. Correct operation is not
guaranteed if this type of SD card is used.
• The SD card is the only evidence that the customer is licensed to use the application program. Also,
the service technician may occasionally need to check the SD card and its data to solve problems.
For these reasons SD cards must be stored with the machine.
• A licensing agreement prohibits copying of the PostScript SD card. However, you can copy any
application from another SD card to the PS3 SD card.
• Once an SD card has been used to combine applications on that card, that SD card cannot be used
for a different function.
• Never remove the System SD Card from Slot 1.
• Before uploading to an SD card, always make sure that the write-protect switch is OFF. (It is very easy
to accidentally turn on the write-protect switch when inserting or removing an SD card.)
Merging Applications onto One SD Card
1. Turn off the machine.
2. Remove the SD card slot cover ( x2).
3. Insert the Source SD card into the SD card Slot C3.
• The PS SD card cannot be copied, but other applications can be copied onto the PS SD card.
4. Check the target SD card and confirm that its write-protect switch is OFF.
5. Insert the Target SD card into SD card Slot C2
6. Turn the machine on.
7. Do SP5873 001.
8. Obey the prompts to complete the procedure.
9. Turn the machine off.
10. Remove the Source SD card from C3. Leave the target SD card in C2.
11. Reattach the SD card slot cover.
12. Turn the machine on.
13. Do SP5990-005 (Diagnostic Report) and make sure the program runs correctly.
14. Return copied SD cards to the customer for safekeeping, or tape the copied SD cards to the
inside of the front door.
• Do not remove copied SD cards from the machine site.
• After an SD card has been copied, it can no longer be used. However, it must be stored in the
machine to serve as proof of purchase by the customer.
1. Installation
112
To Next Page
Loading...
