2. If the surfaces of the tapes do not show “VOID”, remove them from the corners of the box.
• If you see “VOID” on the tapes, do not install the components in the box. Stop the procedure
and contact your Sales Division.
3. When you remove each seal, the “VOID” marks [2] can be seen. In this condition, they
cannot be attached to the box again.
DOS Unit Installation
• The DOS SD card must be inserted in SD card slot C2. Make sure that the Data Overwrite Security
Option G874 is "Type G".
DOS Overwrite Security Unit (G874)
119
To Next Page
