• With the digit for entry displayed on the second line, press [#Enter]. The selected digit is entered
into the position above.
• Repeat this procedure to set all the digits.
5. When you are finished, press [Escape] to return to the previous level. The new settings for
the bit switch are now stored.
Printer Controller Bit Switch Settings
Position: 7 6 5 4 3 2 1 0
Display: 0 0 0 0 0 0 0 0
Bit Switch 1 Default
Do not change these settings.
0
All "0"
1
2
3
4
5
6
7
8
Printer Engine Service Mode
The Printer Engine Service mode is used to check electrical data, change modes, and adjust values.
Here is a quick summary of how to enter and use the Printer Engine Service mode to change the settings
listed in the Service Program Mode Tables.
1. Press and together, hold down for over 5 seconds, release and then press [#Enter].
2. Press or to display “2.Engine”.
3. Press [#Enter].
4. Press or to display the SP code groups.
Service Program Mode
297
To Next Page
Loading...
