Ricoh MT-P2 - Page 299

1. Feed SP1000
2. Drum SP2000
3. Process SP3000
5. Mode SP5000
6. Periphs SP6000
7. Data Log SP7000
8. Data Log2 SP8000
9. Etc. SP9000
1. Press  or  to select the group, and then press [#Enter].
• The 2-line display is rotational. If you press  with “1.Feed” displayed, the display will jump
to "9. Etc.", the last selection. Similarly, if you press  with “9.Etc” displayed, the display will
jump to “1.Feed”, the first selection.
2. While referring to the Service Program Mode Tables, press  or  to select the SP that you
want to change, and then press [#Enter].
• If you see > or >> to the right of a selection name, this means a menu sublevel exists.
3. Follow one of the procedures below to change a setting.
To change a single-digit number setting:
• Press [#Enter]. A number replaces the value at the cursor.
• Press  or  to increase or decrease the number.
• Press [#Enter]. The number selected on the 2nd line replaces the number above.
• Press [Escape] to return to the previous level.
To change a multiple-digit number setting
• Press  or  to move the cursor to the digit that you want to change.
• Press [#Enter]. A number replaces the value at the cursor.
• Press  or  to increase or decrease the number.
• Press [#Enter]. The number selected on the 2nd line replaces the number above.
• Repeat the procedure to enter numbers for the other digits.
• Press #(Escape) to return to the previous level.
To select an item from a list
5. Service Tables
298
5