Ricoh MT-P2 - Tandem Tray Paper Size Change

4. Wire covers [D] ( x 1 each)
5. Bracket [E] ( x 1,  x 1, bushing x 1)
6. Gear [F]
7. Bottom plate lift wire [G]
Reinstallation
• Set the positioning pin [A] in the hole [B], and set the projection [C] in the hole [D].
• Position the wire as shown [E].
• Do not cross the wires.
Tandem Tray Paper Size Change
At the factory, this tray is set up for A4 or LT LEF. Only A4 or LT LEF paper can be used for tandem feed.
Paper Feed
211
3