2. From the table and illustration below, find which gears must be replaced.
Example: For tray 1, if SP7504-012 is high, replace gear A, or if SP7504-008 is high, replace
gear B.
Tray SP7504 12 SP7504 8 SP7504 9 SP7504 10 SP7504 11
Tray 1 Gear [A] Gear [B]
Tray 2 Gear [A] Gear [B]
Tray 3 Gear [A] Gear [B]
Tray 4 Gear [A] Gear [B]
3. Clean the shafts and replace the necessary gears.
4. Replace a gear if its cutout and arrow are not in the same position.
5. When you replace Gear [A] or Gear [B], be sure to put the metal face on the outer side,
and the arrow must be in view.
6. If a replacement gear is not available, do this as a temporary procedure:
• Remove the paper feed unit.
• Remove the gear.
• Clean the gear shaft and inside the gear.
• Attach the gear.
Other Problems
293
To Next Page
Loading...
