• This procedure restores all SP code settings to their factory default settings.
• Before clearing all settings in memory with SP5801, print an SMC report with SP5990. You may
need this for reference to restore previously adjusted settings.
1. Push and together, hold down for over 5 seconds, release and then press [#Enter].
2. Press or to display “2.Engine”.
3. Press [#Enter].
4. Press or to display “5.Mode” then press [#Enter].
5. Press or to display “SP5801/Memory Clear” then press [#Enter].
6. When “Clear All” is displayed, press [#Enter], press [#Enter] again to execute.
<All>
result=OK
Here is a summary of all the settings.
No. Item What It Initializes
001 All All items in this table
002 Engine Clear All settings set for engine and processing
003 SCS System Control Service (ROM update information)
004 IMH Image Memory Handler
005 MCS
Initializes the automatic delete time setting for stored documents.
(MCS: Memory Control Service)
008 PRT Printer defaults
010 WebService Netfile (NFA) management files, thumbnails, the Job login ID.
011 NCS
Network Control Service. IP addresses, SmartNetMonitor for Admin.,
Web Status Monitor settings, TELNET settings
014 DCS Setting DCS (Delivery Control Service) settings
015 Clean UCS Settings User Information Control Service) settings
016 MIRS Settings Machine Information Report Service settings
017 CCS Certification and Charge-control Service settings.
Service Program Mode
301
To Next Page
Loading...
