• If a job is paused and re-started, it counts as one job.
• If the finisher runs out of staples during a print and staple job, then the job is counted at the time the
error occurs.
8381 T:Total PrtPGS These SPs count the number of pages printed by the cus-
tomer. The counter for the application used for storing
the pages increments.
[0~9999999/ 0 / 1]
The L: counter counts the number of pages stored from
within the document server mode screen at the operation
panel. Pages stored with the Store File button from within
the Copy mode screen go to the C: counter.
8384 P:Total PrtPGS
8387 O:Total PrtPGS
• When the A3/DLT double count function is switched on with SP5104, 1 A3/DLT page is counted as
2.
• When several documents are merged for a print job, the number of pages stored are counted for the
application that stored them.
• These counters are used primarily to calculate charges on use of the machine, so the following pages
are not counted as printed pages:
• Blank pages in a duplex printing job.
• Reports printed to confirm counts.
• All reports done in the service mode (service summaries, engine maintenance reports, etc.)
• Test prints for machine image adjustment.
• Error notification reports.
• Partially printed pages as the result of a jam.
8391
LSize PrtPGS [0~9999999/ 0 / 1]
These SPs count pages printed on paper sizes A3/DLT and larger.
8411 Prints/Duplex
This SP counts the amount of paper (front/back counted as 1 page) used for
duplex printing. Last pages printed only on one side are not counted.
[0~9999999/ 0 / 1]
8421
T:PrtPGS/Dup Comb [0~9999999/ 0 / 1]
These SPs count by binding and combine, and n-Up settings the number of pages processed
for printing. This is the total for all applications.
5. Service Tables
396
To Next Page
Loading...
