Ricoh MT-P2 - Page 416

2. Press .
System Ver. 1.00
2. Engine
3. Press [#Enter].
<Engine>
1. Feed
4. Press  to display “5. Mode”.
<Engine>
5. Mode
5. Press [#Enter].
SP5024
mm/inch Display
6. Press  repeatedly to display “Output Check”.
SP5804 >>
Output Check
7. Press [#Enter].
SP5804-001
1st.PaperFeedCl.
8. Press  or  to display the item to check.
SP5804-027
Fuser Exit Motor
9. Press [#Enter].
<Fuser Exit Motor>
10. Press [#Enter] to switch the component on, then press [#Enter] to switch it off.
Fuser Exit Motor
Fuser Exit Motor
11. Press [Escape], then repeat Steps 8 to 11 to check other items.
12. When you are finished press [Escape] until you see “2.Engine”, then select “3.End”.
Input/Output Check
415
5