Riso SF9490 - Inserting Slip Sheet [Slip Sheet Sorting]; Using the Job Separator [Job Separation]

Chapter 5 Useful Functions
95
5
Inserting Slip Sheet
[Slip sheet sorting]
1
Touch [Slip sheet sorting] in the
[Functions] tab screen.
Using the Job Separator
[Job Separation]
1
Touch [Job Separation] in the
[Functions] tab screen.
You can use the paper placed on the paper feed
tray as slip sheets for sorting printed papers.
• When you print with [Auto Process] turned on
after placing originals on the auto document
feeder, turn on [Slip sheet sorting] to insert a slip
sheet (blank sheet) each time the original
changes.
• When you use [Program] (A 90) together with
[Slip sheet sorting], a slip sheet (blank sheet) is
inserted between each separation of the printing.
B[Slip sheet sorting] can be used when
the following papers are placed on the
paper feed tray:
(Standard sizes)
SF9390:
A3p, B4p, A4p, or Foolscapp
SF9490: Ledgerp, Legalp or Letterp
(Custom sizes)
210 mm × 280 mm to 320 mm × 432 mm
(8 1/4 inches × 11 1/32 inches to 12
19/32 inches × 17 inches)
BSlip sheets and printed papers may be
smudged with ink.
BThis function works only when [Program]
(A 90) or [Auto Process] (A 29) is [ON].
BYou cannot use this function with the fol-
lowing functions.
C[Interval] (A 81).
C[Job Separation] (A 95).
C[160ppm] and [190ppm] under [SPEED]
(A 78).
BYou can change the default setting in [Slip
sht sort set.] (A 118) under [Admin.].
You can use the [Job Separation] function after
installing the optional Job Separator.
• When you print with [Auto Process] turned on
after placing originals on the auto document
feeder, turn on [Job Separation] to insert a piece
of tape each time the original changes.
• When you also use [Program] (A 90) together, a
piece of tape is inserted in each separation of the
printing.
For more information, see the user’s guide for the
Job Separator.
BThis function works only when [Program]
(A 90) or [Auto Process] (A 29) is [ON].
BYou cannot use this function with the fol-
lowing function.
C [Slip sheet sorting] (A 95)
BYou can change the default setting in [Job
Separation] (A 118) under [Admin.].