Sanyo SDNR - Spindle Setting; Monitor Item Setting; Data Output Item Setting; Auxiliary Parameter

6. FASTENING SETTING mode (Type M)
6-8
i. Angle indication
The format of the angle indication is set.
Angle indication CONTENTS
**** The format of the angle indication is “***.*”.
***.* The format of the angle indication is “****”.
Table 6.2-10 Digits of angle indication
6.2.2 SPINDLE SETTING
Refer to section 5.2.2 of this manual.
6.2.3 MONITOR ITEM SETTING
Refer to section 5.2.3 of this manual.
6.2.4 DATA OUTPUT ITEM SETTING
Refer to section 5.2.4 of this manual.
6.2.5 AUXILIARY PARAMETER
Refer to section 5.2.5 of this manual.
6.2.6 SYSTEM DRIVER COPY
Refer to section 5.2.6 of this manual.